Tipo MPR10

~ 91 mm

Descripción

The single pole power relays MPR10 and HPR10 have been designed for switching high current loads and for disconnecting the battery from the on-board electrical system. The mechanical power relay type MPR10 is:

are energy saving and help to reduce the CO₂ emissions
are ideally suitable for high loads
can easily be integrated into existing vehicle designs
can directly be used without any changes on the controlgear

The MPR10 is a bistable relay, i.e. a short current impulse is required only for the switching operation. The contact is then held in its position by permanent magnets without current.

NEW! Now also available with robust plug-in connector - compatible with the HDSCS connector series
NEW! Extension to 48 V in the load circuit

Saves time and costs

through quick and fault-free mounting
thanks to isolation of the control contacts from environmental influences
through high resistance against vibration and mechanical stress

Datos técnicos

Voltage rating of load	DC 12 V DC 24 V DC 48 V
Operating voltage of SSRPC	DC 16...32 V DC 9...16 V
Continuous current	100 A 200 A 300 A
Number of poles	1-pole
Physical isolation of load circuit	1 (NO)
Temperature range	-40° C … +85° C
Terminal design	Load terminals M8 or M10 Control terminals M4 resp. HDSCS
Mounting method	M4 connectors side and foot foot flange holes with compression limiter side flange
Design	Cylindrical enclosure
Feature	Mechanical power relay for harsh application conditions. Extremely power saving due to a bistable drive, which only needs energy during switching operations.
Contact system type	mechanical